The ORG - Truly Independent and Unbiased!
Started by BWalker82, 18 May 2011, 06:27 PM
Quote from: George on 15 July 2011, 04:51 AMWas used to my little echonomy car where you could just depress the cylinders with two screwdrivers.Only thing that was new here was it has locking pins that just needs to be knocked out and in.
QuoteI struggled with this monster pressure system but then I remembered someone mention a C-clamp. There's two spots on each pad side where you can fit a hand vice clamp or perhaps a C-clamp, so if you have two of these the job is real easy. Depress one pad at a time using the two clamps at the two ends, gradually adjusting the clamp settings. You need this as the cylinders needs to be FULLY depressed before you can get the new pads in. Use the existing pads to clamp the cylinder all the way back before you take them out.
Page created in 0.051 seconds with 22 queries.