Hi, is there any way to elegantly press the tin cases? Is there a tool for this or do I have to use a hammer. I have doubts about the sealing of the joint.
Greetings! There is a special mandrel for tight rolling
I think there is also an insanely expensive and likely NLA Benz tool for this jobby.
I looked up the part number. Benz calls it "Beading tool for closing protective sleeve":
115 589 36 63 00
In true Benz fashion, of course there is also "Cutting tool for opening protective sleeve":
115 589 40 63 00
Quote from: daantjie on 18 December 2022, 09:41 PMI looked up the part number. Benz calls it "Beading tool for closing protective sleeve":
115 589 36 63 00
In true Benz fashion, of course there is also "Cutting tool for opening protective sleeve":
115 589 40 63 00
I made myself an analogue of this original device.
would you believe it?..! but the local Benz guru in Adelaide has just fabricated this very unit.!
Quote from: dima on 18 December 2022, 11:18 PMQuote from: daantjie on 18 December 2022, 09:41 PMI looked up the part number. Benz calls it "Beading tool for closing protective sleeve":
115 589 36 63 00
In true Benz fashion, of course there is also "Cutting tool for opening protective sleeve":
115 589 40 63 00
I made myself an analogue of this original device.
Hi, any chance that you still have the drawings for this tool?