The Forum

Garage => Mechanicals => Topic started by: celberg on 22 February 2020, 11:04 AM

Title: Parking break
Post by: celberg on 22 February 2020, 11:04 AM
My pedal is not going back enough to put the parking break lamp off. Were is the right place to adjust the cable?
Title: Re: Parking break
Post by: daantjie on 22 February 2020, 01:30 PM
Is it not making contact with the micro switch?
Title: Re: Parking break
Post by: celberg on 22 February 2020, 04:05 PM
No. I use my left foot to pull the pedal up so it does.
Title: Re: Parking break
Post by: rumb on 24 February 2020, 10:31 AM
The cable adjustment is under the car about in the middle. 
Title: Re: Parking break
Post by: celberg on 24 February 2020, 03:53 PM
You mean were the cable split to each wheel? If I tighten the both rear cables, the front cable losens?
Title: Re: Parking break
Post by: rumb on 24 February 2020, 07:36 PM
You just loosen the front cable. While down there make sure there is no binding of the mechanism.
Title: Re: Parking break
Post by: celberg on 08 March 2020, 01:52 PM
I just put some WD40 on the adjustment. That's enough. :)