www.W116.orgAll about the Car!
Started by raueda1, 29 July 2022, 10:24 PM
Quote from: daantjie on 08 August 2022, 03:51 PMAnd another:WUR Tips II.pdf
Quote from: s class on 08 August 2022, 02:39 PMOnce the warm control pressure is on 3.5 bar, you can adjust the enrichment pressure. This is set by the plug on the underside. You need to drive yours in deeper to raise the enrichment pressure to 3.0. DONT overdo it, or you will have to strip the unit ruining the diaphragm in the process to get the plug back out. Use a vernier and go 0.1mm at a time
Quote from: s class on 11 August 2022, 03:58 PMWhilst it doesn't solve your problems, I'll reassure you that 3.5bar is good. The published spec is 3.4 to 3.8, but all the unmolested units I've come across had been factory set to 3.5bar,so that's what I usually target.
Page created in 0.029 seconds with 22 queries.