Location, Location, Location.Please add your location to your profile. It will help others to help you!
Started by TNNBENZ, 24 November 2021, 11:50 AM
Quote from: rumb on 24 November 2021, 08:25 PMYes they are the same. Just take the bracket off. There are 2 plastic bushings, probably new ones are a good idea.
Quote from: UTn_boy on 25 November 2021, 11:12 AMYou simply remove the circlip at the front of the rod, disconnect the ball sockets at the rear of the rod, and then push the rod to the rear of the car against the spring, and it'll angle/slide out. It it is not necessary to remove the bracket unless the intake manifold is being resealed. There are ball type plastic bushings on each end of this rod,....not just on one end. These bushings do crumble away with age, so if they're missing or questionable looking then renew them. Picture below for reference. The smaller part goes inside of the ball, and both face inward to the rod.
Page created in 0.046 seconds with 21 queries.