Still making slow progress but finally i have evaporator/heat exchanger out!
Hey, Major Tom, if you're reading this thread please chime in on the type of foam you used to repair/rebuild your "airbox." So far your thread http://forum.w116.org/interiors-and-exteriors/airbox/
is the only detailed info i have found. Any help would be welcomed.
Joe, If you are around...what rubber bits are available for replacement for this overhaul? The rubber grommets between cabin and wiper area (?) are hard and cracked. Also between firewall and wiper area - especially the right side above exhaust manifold.
There's that missing floor vent pod - i knew it was somewhere.
Evap/heat box and lower vent section
What should i used to clean up the oil tape residue off the expansion valve? Anyone?
Disassembling evaporator hopefully starts tonight!