News:

Please add your location to your profile. It will help others to help you!

Main Menu

300SD Hood Springs

Started by Nutz, 08 July 2006, 11:24 AM

Nutz


Stupid question but are the diesel hood springs of the same "tension" as gas model hoods  ??? I have an aluminum hood that I'm going to put on Darth but I didn't save the springs when I disassembled my old 300SD.

Mforcer

I suspect that if you use the steel-hood springs, you'll have some trouble closing the aluminium-hood due to the difference in weights. You may not even be able to close the hood at all but it would probably be worth trying. Let us know how you go.
Michael
1977 450SE [Brilliant Red]
2006 B200

cipha

It may be nice to fin a spare 300SD bonnet and put it on a petrol powered car [say 450] and get some weight off the front end.

SHame that this model wasn't sold downunder.

Des

dont the 300SD's have an aluminum boot lid too?

sorry to get off topic


Nutz

Quote from: Des on 10 July 2006, 01:33 AM
dont the 300SD's have an aluminum boot lid too?

sorry to get off topic



I checked out my spare 300SD boot lid and a magnet stuck to it.

alabbasi

The boot lid is made of aluminum, but the frame isn't. I have both sitting in my garage and there is a weight difference between the two.
With best regards

Al
Dallas, TX USA.

Nutz

Quote from: alabbasi on 11 July 2006, 05:54 PM
The boot lid is made of aluminum, but the frame isn't. I have both sitting in my garage and there is a weight difference between the two.


I may be mistaking but I've heard that the aluminum boot is only found on one year of the 300SD's  ??? My boot is off  an '80 300SD but that's not to say it hasn't been changed off sometime before I owned it.